Het vertalen van dit artikel kan beginnen.

4.4.4. pH verlagen

Foto van auteur

Auteur : David Bogert

Gepubliceerd :

Tijd om te lezen :
7 minuten
Difficulty : Level 7

Excerpt :

Dropping a high aquarium pH can be difficult.
Newcomers constantly ask on social media “How do I get my pH down for my fish?”. First off, if the pH is below 8.5 you typically don’t need to bring it down for most fish. Even black water Amazonian fish do well at anything lower than 8.5 pH.

If you have an aquarium with a pH above 7.5 it is normally very difficult to get the pH down. This is because water with a pH above 7.5 normally has a lot of bicarbonates and carbonates (KH) which buffer the water. This means you must add a large amount of acid to get the pH down.

Mikrogeophagus ramirezi, Short Body Ram
Mikrogeophagus ramirezi – Short Body Ram

The power of KH (carbonate hardness) to buffer to a pH above 7.5 is amazing. An illustration is when I had an aquarium where I wanted to drop to a 6.6 pH for an Amazon biotope I was setting up. The aquarium was filled with only water and had vigorous aeration with multiple air stones. The water was a pH of 8.2, KH of 400 (dKH of 22) and GH of 120 (6 dGH).

I added Indian Almond leaves and waited a week. The pH held at 8.2 pH. Indian Almond leaves, oak leaves, alder cones, beech leaves and some driftwood contain tannic acid, a brown weak organic acid. This weak acid is totally ineffective in reducing the pH of high KH water, contrary to popular myth.

So, I added a teaspoon of phosphate acid buffer. Nothing happened, the pH held at 8.2. I added another 5 teaspoons acid buffer and the pH dropped to 7.8. One day later the pH was back to 8.2. I added another five teaspoons of acid buffer, still no permanent change. Acid buffer is very weakly acid and again not effective in reducing the pH of a high KH water.

Copadichromis borleyi Red Fin Borleyi
Copadichromis borleyi – Red Fin Borleyi

So, I added one teaspoon of concentrated hydrochloric acid and the pH dropped to 7.2. One day later the pH went back up to 8.2. So, for two weeks I added roughly a teaspoon of acid every day to the aquarium and repeated this cycle. Finally, after two weeks, the pH stabilized at 6.6. I had added almost one-third cup of concentrated hydrochloric acid to the aquarium. This amazed me.

The exact mechanism of this is simple. The acid converted the carbonate ions in the water to carbonic acid, which is simply a solution of carbon dioxide in water. Carbon dioxide TEMPORARILY drops the pH of the water. The carbon dioxide slowly outgassed to the atmosphere over a 24 hour span and the pH went back up. This is why KH is defined as the “buffering” capacity of the water. Over a span of two weeks the acidity finally came down permanently. But it took a full two weeks and a lot of acid to do the trick, even with very good aeration removing the carbon dioxide.

Now obviously if the KH is low, like below 3 KH, this buffering effect is much less and it is much easier to drop high pH. But water with a low KH and a high pH is rather unusual.

Maylandia fainzilberi Magunga
Maylandia fainzilberi – Magunga

Methods to Drop pH Effectively.

Sometimes there are legitimate reasons to drop the pH, for instance if the pH is over 8.5. One person on social media had a pH of 9.2, which is a situation which must be remedied. Ammonia becomes very toxic over 8.5 pH.

There are only three real ways to effectively drop the pH, garbage bin treatment, RO water and rainwater:

1 Garbage Bin Treatment Center

To do this one needs to set up a treatment center the size of the amount of water used for water changes. This can be a spare aquarium, a plastic bin, a garbage bin or even a barrel.

Then follow this “titration” process:

  • Fill with water.
  • Add one teaspoon concentrated hydrochloric acid (muriatic or pool acid) per twenty-five gallons (100 liter) of water for every half a pH over 8.0 (i.e. 8.5 pH gets one teaspoon, 9.0 two teaspoons).
  • Aerate the container with a large air stone and air pump.
  • Wait two days for the resulting carbon dioxide to gas out.
  • Measure the pH
  • If the pH is above 8.0 repeat the process only with less acid.
  • Continue the process with continually decreasing amounts of acid.
  • If the pH is below 8.0 you are good to go

Do not try to “chase” pH below 8.0 pH. You will invariably end up with something like 5.8 pH, which isn’t productive. Note once you know the amount of concentrated acid required you don’t need to wait the two days and repeat.

Any hydrochloric acid will do the job. And by adding hydrochloric acid to high GH and KH water you will simply convert calcium carbonate to calcium chloride (a harmless stable “salt”) and carbon dioxide. Calcium chloride will not evaporate or change. It does take up to a week (90% will be in two days) for the carbon dioxide to work its way out of the system. So expect the pH to rise over the span of a week after adding the hydrochloric. But after a week the pH will be very stable.

Note that concentrated acid requires heavy duty plastic gloves and goggles to use. Follow all the precautions on the label. Concentrated acid can burn very severely.

picture of an aquarium fish Tropheops tropheops Red Top Chilumba
Tropheops tropheops – Red Top Chilumba

2 RO water

This needs a RO (reverse osmosis) set up. RO will drop the pH of water. But it is wasteful of water and expensive if you pay for your water. Note some use RO/DI units (reverse osmosis, deionization) units. This is counter productive as the small amounts of ions removed by the deionization units are needed by fish.

Note also that the membranes can need frequent changing if the water is very hard. And note RO units and chloramine in the water doesn’t mix very well. Activated carbon is of limited use with chloramine (it need a long residence time and the carbon must be replaced every two weeks) and chloramine will destroy RO membranes.

For a small aquarium it is possible to buy RO water or distilled water in the store. Note that RO and distilled water typically benefit by adding some salt (table salt, baking soda and/or Epsom salts) back into the water, up to 70 to 150 TDS. Even Amazon fish cannot survive in truly reverse osmosis water (< 1 dGH).

Also note that if one mixes 50% RO water in water which is 8.6 pH you might see a decrease to 8.4 pH if one is lucky. This all has to do with the buffering mentioned above. One must add 100% RO water and bring it up to 70 to 150 TDS.

3 Rainwater

Rainwater is a perfectly acceptable source of soft water. There are no toxins in it, contrary to popular myth. It is always a good idea to strain it through cheese cloth to remove mosquito larvae.

picture of an aquarium fish Maylandia msobo, Magunga
Maylandia msobo – Magunga

pH in meer detail

Voor diegenen die geïnteresseerd zijn in een meer diepgaande bespreking van pH, klik op de volgende links:

Link naar algemene discussie over pH:

4.4. Aquarium pH

Link to a more in depth discussion of pH and how unimportant it is in the aquarium:

4.4.1. pH is Not Important

Een moeilijk te begrijpen onderdeel van pH is het concept van "buffering". Sommigen vinden het belangrijk om een aquarium te bufferen.

4.4.2. Het bufferen van het water

De pH gaat constant op en neer in een aquarium vanwege koolstofdioxide en hoe het in wisselwerking staat met water. Dit is een ander relatief complex onderwerp:

4.4.3. Kooldioxide en pH

There are situations when one has a pH lower than 6.5 and one needs to raise the pH. This link covers how to safely raise the pH of water

4.4.5. pH verhogen

Protomelas spilonotus Tanzania
Protomelas spilonotus -Tanzania

Veel mensen denken dat vissen die in een breed scala aan wateren zijn gekweekt, dus een breed scala aan wateren kunnen verdragen. Dit is gewoon een mythe.

4.7. Vis tolerantie van pH

En velen denken dat vissen in een zeer stabiele pH of temperatuur moeten worden gehouden en dat snelle veranderingen schadelijk zijn voor de vissen. Dit is weer een andere mythe.

4.8. Stabiliteit is niet belangrijk